S650TX Mini Skid Steer
Starting Procedure 22-1
Section 22: Starting Procedure
S
TARTING
THE
E
NGINE
Step 1:
Stand with both feet on operator platform.
Step 2:
Move
Ground Drive Joystick
(1)
to NEUTRAL.
Step 3:
Move
Auxiliary Attachment Drive Lever
(2)
to NEUTRAL.
Step 4:
Move
Throttle
(3)
to half throttle position.
Step 5:
If ambient temperature is below 50°F (10°C), turn ignition key
(4)
to
RUN position, then press
Glow Plug Button
and hold for 10–15 seconds.
Continue to hold button while starting engine.
Step 6:
Turn ignition key to START position; release when engine starts.
If engine does not start within 10 seconds, turn key OFF, wait 30
seconds, then start engine starting sequence over again. Do not allow the
starter motor to run continuously for more than 20 seconds.
Step 7:
Check to see that oil pressure warning light goes off. If not, shut off engine and correct problem.
Step 8:
Warm up engine at medium speed. Do not operate the engine under load until engine has warmed up.
1
3
2
4
Summary of Contents for S650TX
