30-8 Transporting the Machine
S650TX Mini Skid Steer
Step 13:
Tighten bypass valves
(3)
prior to returning unit to service. These valves
must be fully closed after towing for normal tractor operation. Torque
bypass valves to 15–18 ft-lb (20–25 Nm)).
NOTICE:
Do not attempt to push-start the machine. Damage to ground drive pumps or
motors will result if towing instructions are not followed correctly.
Clean Machine
NOTICE:
Machine controls and electrical/electronic devices are not rated to withstand high pressure water and
temperature power washers. Water intrusion will likely cause malfunction or damage to any devices hit directly
by the water spray. Keep pressure washer stream away from machine controls and electrical/electronic devices.
Compressed air can also push moisture through some connector and component seals. Do not point air nozzle
directly at seal areas.
3
Summary of Contents for S650TX
