Carpo 4 Deluxe
2012-04
Page 22
Check all around on both sides that the tube is not pinched between the rim and the edge of the tyre.
Lightly push the air valve inwards and pull it out again to make sure that the tyre is positioned properly
in the region of the air valve.
To ensure that the wheel is inflated correctly, admit only so much air initially that the tyre can still be
easily pushed inwards by using your thumbs. If the check-lines are equidistant from the edge of the
rim on both sides of the tyre, then the tyre is centered properly. If not - let out the air and position the
tyre afresh. Now the tyre can be inflated to its full operating pressure (note the maximum) and the
valve cap should be replaced.
Only an expert can guarantee correct assembly. Work not done by your specialist dealer, would void
any warranty claims.
When inflating the tyres, always check that the pressure is correct. The correct pressure is given on
the tyre walls.
Use only inflating equipment which complies with regulations and indicates the pressure in bar. We do
not accept any liability for damage caused by using inflation equipment not supplied by the
manufacturer.
3.8 Thermal fuses
To protect the motor against overload, your scooter
have a thermal safety mechanism
on the rear of
your scooter. The thermal fuse will automatically cut
the motor to prevent overheating and thus rapid wear
and tear or breakdowns. You can access the thermal
safety device through a gap in back of the synthetic
cover. For those models that have no synthetic cover,
the thermal safety mechanism will be located on the
battery boxes.
The thermal safety device can go loose if you go up or down slopes that exceed the maximum
gradient indicated. Nominal loads that exceed the maximum permitted could also cause the device to
jump out. Likewise, if you keep on driving with the engine brake on, it could result in overload. The
maximum values not to exceed are indicated in the chapter on “Technical Details” of the
corresponding manual.
To be able to use the scooter again, remove the overload and wait till the motor has cooled off. Then
gently press the thermal safety mechanism back in. Your scooter is now ready for use again.
3.9 Tip protectors
A tip protector is fixed to the frame of the scooter on the back side. It is thus not possible to remove it.
The tip protector is there for your safety. It prevents the scooter from tipping over backward when you
drive over small obstacles that do NOT exceed the maximum height specified.
1
Summary of Contents for Carpo 4 deluxe
Page 1: ...VERMEIREN Carpo 4 deluxe I N S T R U C T I O N M A N U A L ...
Page 37: ... Notes ...
Page 38: ... Notes ...
Page 39: ... ...
