Instruction manual Carpo 3 / Carpo 4
Last updated: 2017-02
7
Front tyre Carpo 3:
DISMANTLING
1.
Unscrew and remove the middle screw
that attach the tyre (1), (2), (3), (4) to the
front fork of the scooter.
2.
Let the air out of the wheel by lightly
pressing the pressure pin on the valve.
3.
Unscrew the 4 screws of the rim to
separate the rim sides (3), (4) and flange
(5).
ASSEMBLY
Insert the partly-filled inner tube into the tyre.
1.
Connect the two sides of the rim (3), (4) through the tyres and place the flange against the tyre
and screw them back again with the 4 screws.
2.
Put the air valve through the hole for it in the rim.
3.
Inflate the wheel to the recommended tyre pressure. Put the wheel (1), (2), (3), (4) and flange (5)
back on the front fork of the scooter and secure these connection with the middle screw.
Rear tyre Carpo 3:
DISMANTLING
1.
Remove the cover cap for scooter rim
(8).
2.
Unscrew and remove the middle screw
(12) that attach the wheel (1), (2), (3), (4)
and flange (5) to the scooter.
3.
Let the air out of the wheel by lightly
pressing the pressure pin on the valve.
4.
Unscrew the 4 screws (6) of the rim to
separate the rim sides (3), (4) and flange
(5).
ASSEMBLY
Insert the partly-filled inner tube into the tyre.
4.
Connect the two sides of the rim (3), (4) through the tyres and place the flange against the tyre
and screw them back again with the 4 screws (6).
5.
Put the air valve through the hole for it in the rim.
6.
Put the wheel (1), (2), (3), (4) and flange (5) back on the scooter and secure these connection with
the middle screw (12). Inflate the wheel to the recommended tyre pressure.
7.
Replace the cover cap for scooter rim (8).
