, 30°
2011-06
1.
Remove the screws
.
2.
Adjust the height of the tip cap to a
comfortable position.
Tip cap height
Tube tip cap
!
!
!
!
Tube frame
"
"
"
"
150 mm
(Standard)
Hole 1 and 3
Hole 1 and 3
165 mm
Hole 1 and 3
Hole 2 and 4
Table 5: Tip cap heights for wheelchair with standard
seat height of 500 mm
3.
Tighten the screws properly
.
(Fig C)
If an anti-tip device is installed, it replaces the addition of the tipping lever and can be used
accordingly.
3.12 Adjusting the stability and the maneuverability
WARNING:
Risk of injury - Make sure that all screws are properly tightened with
the appropriate tool.
WARNING:
Risk of injury - Make sure that the axle adapters
of the rear
wheels on both sides are mounted in the same position.
WARNING:
Risk of tipping over - Be aware that you change the stability of the
wheelchair.
The driving wheels are mounted in an axle adapter
at
the bottom of the back frame
.
1. Loosen the fixing screws
.
2. Turn the axle adapter
to the back until the axle
mounting is behind the back frame.
3. Tighten the screws properly
.
4. Adjust the brakes.
For the 30° there shall be standard an anti -tipping device mounted on the wheelchair
when the axle adapter
is positioned to the front.
4
Maintenance
Lifetime of the wheelchair is influenced by its use, storage, regular maintenance, servicing
and cleaning.
4.1 Regular Maintenance
The maintenance activities to ensure a good condition for your Vermeiren wheelchair are
described below:
•
Before every ride
Check the tyres and make them clean. If necessary change the tire.
Check screw fastenings are secured.
Check the brakes and adjusted if necessary.
Check the wheelchair (cleanliness, cracks, damage on structural parts ... .)
and make it clean. If necessary change the coating.