Express
2012-03
Page 22
Next, connect the charger cable with the three-pin plug to the loader socket on the electric
wheelchair's operator unit. Once connected to the batteries, the charger automatically begins
charging. Now only the yellow LED is active.
When charging is complete, the yellow LED goes out and the green LED comes on. Now
remove the charger cable from the operator unit. The charger switches back to STAND-BY
mode (yellow and green LEDs active).
If the charger cable is not removed, a tiny current will keep the batteries topped up (trickle
charging).
If you decide not to use your electric wheelchair for an appreciable period, you must
nevertheless recharge it regularly to keep it in a running condition ready for immediate use.
The manufacturer accepts no liability for damage caused by improper charging.
For further information, please refer to the user instructions provided with the charger.
2.22 Thermal fuse
To protect the motor against overload, on the
back of the wheelchair topside of the battery
housing, there is a thermal safety mechanism
that will automatically cut off the motor to prevent
overheating and thus rapid wear and tear or
breakdowns. This can occur if you go up or down
slopes that exceed the maximum gradient
indicated.
Nominal
loads
exceeding
the
maximum
could
also
trigger
the
safety
mechanism.
To be able to use the electric wheelchair again, remove the overload and wait till the motor
has cooled down. Then gently press the thermal safety mechanism back in. Your wheelchair
is now ready for use again.
3
Installation and adjustment
The instructions in this chapter are for the specialist dealer only.
The Express has been designed as a rear wheel drive electric wheelchair.
L
L
L
L
WARNING:
Risk of unsafe settings - Use only the settings described in this
manual.
L
L
L
L
WARNING:
Risk of tipping over - Variation allowed adjustments can still change
the stability of your wheelchair (tilt back or sideways).
3.1 Tools
To set up the wheelchair the following tools are needed.
•
Wrench set n° 8 to n° 19
•
Allen keyset n° 3 to n° 6
•
Screwdriver Phillips head