Forest 3
2014-12
Page 25
* Adjusting width armrest
Adjust the width of the armrests as follow
(range 25 mm: stepless / on each side):
1. Loosen
the
screws
on the back of the
wheelchair just below the seat frame.
2. Adjust the armrest to a
comfortable
width.
3. Tighten
the
screws
properly.
Check that the armrests are positioned
identically on both sides.
The minimum and maximum adjustment will
be indicated by the triangle. The triangle must
be completely visible.
3.3.5 Adjusting footrests
* Adjusting width footrests:
1. Loosen the two screws
Ⓐ
on the front of the
seat frame.
2. Move the footrest in an horizontal direction
until the correct seat with, by moving the
square tubes
Ⓑ
and
Ⓒ
over each other (3
different positions: steps 15 mm on each
side).
3. Retighten the screws
Ⓐ
properly.
4. Repeat instructions above for the other
footrest.
* Adjusting length footrests:
L
CAUTION:
Risk of damage – Avoid that the footrests make any contact with the
ground. Keep a minimum distance from 50 mm above the ground.
Adjust the length of the footplates as follow:
1. Remove the screw
Ⓐ
.
2. Adjust the length of the footrest to a
comfortable length (range: 120 mm, steps 20
mm).
3. Tighten the screw
Ⓐ
properly.
Check that the footrests are positioned
identically on both sides.
MINIMUM
MAXIMUM