Forest, Forest Narrow
2012-12
Page 13
The armrests are adjustable in different heights over a range of 100 mm (stepless).
1. Loosen the lever a little.
2. Move the square tubes
and
over each other until the desired armrest height.
3. Retighten the lever hand-tightened.
4. Check that the lever is securely fixed.
5. Adjust the other armrest with the same instructions.
2.5 Mounting or removing of the footrests
L
L
L
L
CAUTION:
Risk of injury – Make sure that you hold on the upper curve to prevent
your fingers from getting caught and hurt.
L
L
L
L
CAUTION:
Risk of injury – Make sure that the footrests are firmly fixated.
The mounting of the footrests is
done as follows:
1. Hold the footrest sideways at the
outside of the wheelchairs frame
and mount the pins into the
holes .
2. Turn the footrest inwards till the
pin click in the hole of the
attachment point . The lever
must point backwards. If the
footrest does not engage
immediately, push them lightly
inwards.
3. Turn the foot plates downwards.
To take off the footrests:
1. Fold the foot plates upwards.
2. Pull or push on lever .
3. Turn the footrest to the outside of the wheelchair until the hole comes loose of the pin
from attachment point .
4. Pull the footrest upwards until the pins come out of the holes .
2.6 Suspension
L
L
L
L
CAUTION:
Risk of injury – Set the range of both springs identically.
The strength of the springs above the drive motors can be adjusted to enhance your comfort.
These springs are located on the back of the electrical wheelchair, next to the battery cover.
If you turn the adjuster
to the left, the range of the
spring lengthens and the suspension becomes softer.
If you turn the adjuster
to the right, the range of the
spring shortens and the suspension becomes firmer.
