Forest, Forest Narrow
2012-12
Page 16
2.10 Transfer in and out the electric wheelchair
L
L
L
L
WARNING:
Power down the wheelchair before getting in or out the wheelchair.
L
L
L
L
CAUTION:
In case you cannot perform the transfer in a safe manner, ask
someone to assist you.
L
L
L
L
CAUTION:
Risk of injury – Do not use the joystick, footplates, armrests as
support.
L
L
L
L
CAUTION:
Risk of tipping over of the wheelchair – Do not stand on the footplates.
1. Park the electric wheelchair as close as possible to
the place where you want to transfer.
2. Check that the operator unit is switched off. Make
sure that the wheelchair is NOT in freewheel
mode.
3. Fold the footplates upwards to prevent standing on
them.
4. If the transfer is on the side of the wheelchair,
remove the armrest on that side.
5. Transfer to / from the electric wheelchair.
2.11 Correct position in the electric wheelchair
Some recommendations for a comfortable use of the electric wheelchair:
1. Position your backside as close as possible to the backrest.
2. Make sure your upper legs are horizontal – If needed adjust the length of the footrests.
2.12 Driving the electric wheelchair
L
L
L
L
WARNING:
Risk of burns – Be careful when driving in hot or cold environments
(sunshine, extreme cold, etc.) for a sufficient amount of time and when
touching - Surfaces can assume the environment temperatures.
L
L
L
L
WARNING:
Risk of unsafe settings - Use only the driving characteristics
described in this manual.
2.12.1
Preparing the electric wheelchair for use
When you start using your electric wheelchair, make sure that it is standing on level ground.
All wheels must be in contact with the ground.
1. Make sure that the freewheel mode is OFF and the operator control is switched off.
2. Adjust the wheelchair best suited for yourself.
3. Set the operator control in the most comfortable position.
4. Sit down on the seat and verify that both armrests have been adjusted so your
forearms are folded down.
5. Put your wheelchair on with the "ON/OFF" button from the operator control.
Now put the speed control on the operator control to the minimum position. Your electric
wheelchair is now ready for use.
2.12.2
Handling after usage
Before getting off from your electric wheelchair, make sure that all four wheels touch the
ground simultaneously.
Push on the "ON/OFF" button from the operator control, to switch off the wheelchair. The
display of the operator control goes out.
