Inovys II-E
2017-02
Page 22
3.5 Adjust the seat depth
L
WARNING:
Risk of injury – Make sure that all screws are secure and properly
tightened.
The seat depth can be adjusted in 3 positions (steps 20 mm). Adjust the seat depth
according following rules:
Seat depth
Hole
480 mm
500 mm
520 mm
Table 3: Seat depth
1. Loosen the screws
Ⓐ
beneath the
front seat frame.
2. Pull or push the front of the seat frame into
the
desired
position.
3. Retighten the screws
Ⓐ
firmly again.
Note: When rebuilding the seat depth in the back frame area, the displacement of the motor
for adjusting the back is changed and a gap can occur between the back and seat cushions.
The seat depth can also be changed by adjusting the brackets of the backrest. With these
adjustment you can become a minimum seat depth of 460 mm.
1. Remove the backrest.
2. Loosen the bolts
of the four
brackets.
3. Adjust the brackets more to the front
or back until the desired seat depth.
4. Retighten the bolts
of the four
brackets.
5. Replace the backrest.
Summary of Contents for Inovys II-E
Page 1: ...VERMEIREN Inovys II E I N S T R U C T I O N M A N U A L...
Page 31: ......