RAPIDO Instructions Manual
Status: April-03
25
4.
zzzz
_
zzzz
_
Right motor (or
connection)
defective.
As described above.
Nr.
Blinking Sequence
Problem/Fault
Checking
5.
zzzzz
_
zzzzz
_
One of the parking
brakes (or
connections) of the
motors is defective.
1. Check whether the plugs of the
motors are properly inserted.
2. Check the plug
contacts for corrosion or
damage.
3. Check the
parking brakes. Using an
Ohm meter, measure the
resistance of the connections.
If this is more than
100 Ohms or less than 20
Ohms, the parking brake is
probably defective.
6.
zzzzzz
_
zzzzzz
_
Not in use
--
7.
zzzzzzz
_
zzzzzzz
_
Battery voltage too
low.
1. Check wether the
supplied charger is
connected properly.
2. Check whether the battery
charger indicates "Charge".
3. Check whether the batteries
are actually being charged
(fully discharged).
4. Check whether the so-called
"Memory-Effect" does allow
sufficient capacity to be
accumulated (or not) for the
correct operation of the steering
elements.
8.
zzzzzzz
_
zzzzzzzz
Overcharging of the
Battery.
1. Check whether other than the
supplied charger is used.
2. Check whether the charger
is in order.
3. This fault can also be indicated
by connecting the wheelchair to
external sources of current.
4. Using a multimeter you could
check whether the voltages
of the batteries as given by
the manufacturer correspond
and are less than 32 V.
9.
zzzzzzzzz
_
zzzzzzzzz
_
Communications
errors
1. Check the plug connections
between steering and
module. In the DX-BUS cable a
transfer error occurs.
2. Check the plugs for
corrosion or damage.
3. Check the cable for
damage and whether there
is a break in the cable
(Multimeter).
ATTENTION: The error code can
be deleted by switching the
steering off and on. The problem
