SE04
2019-11
Troubleshooting
16
EN
NL
5
Troubleshooting
Risk of injuries and damage to the operating console or wheelchair
•
NEVER attempt to repair the operating console yourself.
•
For failures of the operating console, you need to contact your specialist dealer.
He/She decides if the console needs to be reprogrammed.
In case of failure, a fault code is displayed by the blinking LED in the ON-OFF button or by a
triangle on the touch screen, see Figure 4.
The following table summarises the possible fault codes. Some problems can be solved by
yourself. For all problems marked in grey, consult your specialist dealer.
Table 2: Troubleshooting
Code Problem
Meaning
1
Remote / joystick failure
Verify that the joystick is in the neutral position when switching
ON the operating console.
Check the joystick: not damaged and working properly.
2
Network or configuration
failure
1. Check all connection points and cables.
2. Verify the correct working of the software.
If you cannot find any fault, contact your specialist dealer.
3
Left motor
(or its connection)
is defective.
1. Verify whether the plugs of both motors have been inserted
properly.
2. Check the plug contacts of both motors for corrosion or
damage.
This fault also appears when the motors are disconnected.
Connect again and restart the system.
4
Right motor
(or its connection) is
defective.
As described above.
5
Left parking brake
(or its connection)
is defective or neutral
active.
1. Verify whether the motors' plugs have been inserted properly.
2. Check the plugs for corrosion or damage.
6
Right parking brake
(or its connection)
Is defective.
As described above.
7
Module failure
(other than Remote)
One of the wheelchair parts may be damaged except the operator
control.
WARNING
Summary of Contents for SE04
Page 4: ...This page is intentionally left blank ...
Page 133: ......
Page 134: ......
Page 135: ......
