Squod
2013-09
Page 23
2.23 Thermal fuse
To protect the motor against overload, on the
right side of the wheelchair frame, there is a
thermal
safety
mechanism
that
will
automatically cut off the motor to prevent
overheating and thus rapid wear and tear or
breakdowns. This can occur if you go up or down
slopes that exceed the maximum gradient
indicated.
Nominal
loads
exceeding
the
maximum
could
also
trigger
the
safety
mechanism.
To be able to use the electric wheelchair again, remove the overload and wait till the motor
has cooled down. Then gently press the thermal safety mechanism back in. Your wheelchair
is now ready for use again.
3
Installation and adjustment
The instructions in this chapter are for the specialist dealer only.
The Squod has been designed as a rear wheel drive electric wheelchair.
L
L
L
L
WARNING:
Risk of unsafe settings - Use only the settings described in this
manual.
L
L
L
L
WARNING:
Risk of tipping over - Variation allowed adjustments can still change
the stability of your wheelchair (tilt back or sideways).
3.1 Tools
To set up the wheelchair the following tools are needed.
•
Wrench set n° 8 to n° 19
•
Allen keyset n° 3 to n° 6
•
Screwdriver Phillips head
3.2 Manner of delivery
The electric wheelchair shall be delivered with:
•
Framework with arm supports, rear and front wheels, seat and backrest
•
1 pair of footrests
•
2 x drive bat battery housing, 2 x drive motors
•
Impulse S charger (6A) + manual of Impulse S charger
•
Tools
•
Operator unit + manual operator unit
•
Accessories
Before use, check that everything is included and that no products are damaged (example
by transport, ...). Please note that the basic configuration may differ in different European
countries. Contact your specialist dealer.
Summary of Contents for Squod
Page 1: ...VERMEIREN Squod I N S T R U C T I O N M A N U A L ...
Page 31: ......
