24
7. INSPECTION AND MAINTENANCE
1.Position the front and rear sections of Venus3/4.
2.Align the lower curved locking brackets of the front section with
the corresponding pegs on the front of the rear section.
3.Plug in electrical connector to connect the front and rear sections.
4.Holding the lower seat post, slowly pivot the rear section forward until
the curved locking brackets are fully connected on to the top rear pegs.
5.Loosen tiller adjustment knob, raise the tiller to the desired position, and then tighten the
tiller adjustment knob.
6.Reinstall the upper seat post at the desired height. Secure with the locking pin and tighten
the seat post knob.
7.Reinstall the batteries by lowering it in to place.
8.Replace the seat and rotate it until it locks into its correct position.
1
Warning
After assembling the Venus3 , make absolutely certain the tiller adjustment knob is fully
tightened.
Summary of Contents for venus 3 t3g
