Venus 3, Venus 4
2014-03
Page 11
L
CAUTION:
Risk of pinching - Do not place fingers between the components of the
scooter (frame, backrest).
Never use your scooter as a seat in an automobile or other vehicle. Indicate on the serialnumber label
with following symbol.
No tools are needed to assemble or disassemble your scooter.
To disassemble, please proceed as follows:
Switch the scooter off.
Place the free wheel mode lever in the drive position.
Fold the backrest to the front (see "Folding the backrest" chapter).
Remove the seat (see “Adjusting the seat” chapter).
Unlock the battery lock part and rotate the battery lock part.
Lift the battery housing out the scooter (see "Changing the batteries" chapter).
Remove the shopping basket (see "Mounting / removing the shopping basket" chapter).
Fold the steering column down (see "Adjusting the steering column" chapter).
Lock the front wheels (see "Locking steering wheels" chapter).
Remove the rear frame from the front frame (see "Mounting / removing rear frame" chapter).
To reassemble, please proceed as follows:
Place the free wheel mode lever in the drive position.
Mount the rear and front frame in each other (see "Mounting / removing rear frame" chapter).
Move the steering column upwards (see "Adjusting the steering column" chapter).
Mount the shopping basket (see "Mounting / removing the shopping basket" chapter).
Mount the battery housing (see "Changing the batteries" chapter).
Mount the seat (see "Adjusting the seat" chapter).
Fold the backrest to the back (see "Folding the backrest" chapter).
Unlock the front wheels (see "Locking steering wheels" chapter).
Turn the key to "ON". Make sure the battery gauge indicates sufficient power.
2.4 Operating the brakes
The scooter is foreseen from regular and parking brakes according STVZO (the German traffic law).
Let go of the joystick to stop the scooter and activate the regular brakes / electromagnetic brakes.
With the freewheel device you can operate the parking brakes.
