75
User Guide ’14 Analogsynthesizer
EN
Controlling Mono Lancet MIDI-parameters using the
’14 Analogsynthesizer
Mono Lancet is a monophonic analog synthesizer expander-module made by VERMONA. Some
parameters of this synthesizer and its current successor (Mono Lancet ’15) can be adjusted using
MIDI control change commands (CC). The ’14 Analogsynthesizer can send these commands. Hence,
the Mono Lancet is a perfect expansion to the ’14 Analogsynthesizer and vice versa.
The functions of the Mono Lancet will not be described here. Find details and information in the
corresponding manual.
Carry out the following steps to send the control change messages (CC):
1. Make sure, the ’14 Analogsynthesizer is in standard play-mode (
ARPEGGIATOR
switch
i
set to
OFF
).
2. Enter the edit mode by pressing the
[EDIT]
button – the corresponding LED will be lit.
3. Use the
select dial to select the EDIT parameter
[10] MONO LANCET CC#
* – the yellow LED
above the
VALUE
button will start blinking.
4. Activate the parameter using the
VALUE
button.
5. Select the desired control change message (CC):
1. Pitchbender on/off
2. Modulation wheel on/off
3. Aftertouch on/off
4. Velocity on/off
5. Filter-Velocity on/off
6. Auto-Glide on/off
7. Legato on/off
6. Activate/deactivate the control change (CC) message using the
VALUE
button. With the
corresponding LED being lit, the respective command is enabled
7. Exit EDIT mode by pressing the
[EDIT]
button again.
H
Steps 5 and 6 can be repeated as many times as needed without leaving the EDIT
mode. Edits are send out immediately.
