6
Connecting instruments directly
1. Connect the supplied power cord to the
MAINS IN
jack
y
on the DSR-3's rear panel. Connect
the power cord to a power receptacle.
2. Connect the at least one of the inputs
q
,
j
or
k
to an audio source.
3. Connect the at least one of the outputs
g
,
h
to an audio input of your mixer, audio-interface
or amplifier.
☛
The in- and outputs on the DSR-3's rear panel are assigned to the channels
SPRING REVERB A and SPRING REVERB B. Therefore, an input signal being
connected to SPRING REVERB A will not be output from SPRING REVERB B.
An exception is the front input
q
which feeds both channels in parallel.
4. Use the
POWER
switch
t
on the DSR-3's rear panel to switch the unit on.
Using the DSR-3 in a mixer's effect loop
1. Connect the supplied power cord to the
MAINS IN
jack
y
on the DSR-3's rear panel. Connect
the power cord to a power receptacle.
2. Connect the at least one of the inputs
q
,
j
or
k
to effect send(s) (i.e. of a mixing console).
3. Connect at least one of the outputs
g
,
h
to effect return(s) (i.e. of a mixing console).
4. Use the
POWER
switch
t
on the DSR-3's rear panel to switch the unit on.
Summary of Contents for DSR-3
Page 1: ...Bedienungsanleitung User Guide DSR 3...
Page 17: ...16...
