9
EN
SYNC switch
e
The
SYNC
switch
e
offers three positions:
OFF, SYNC and CLK.
H
Modulator
q
only offers OFF and CLK positions since it can only be used as a sync reference
but cannot be synchronized itself.
OFF: The Modulator runs at the speed set with the corresponding
SPEED
w
control.
SYNC (indicated by the numbers
q
,
w
and
e
): The Modulator is synchronized to its left counterpart. It follows
the clock-reference’s speed. By this, multiple Modulators can be varied in frequency at once using the
SPEED
control
w
of the Modulator acting as clock-reference. In sync-mode,
SPEED
w
controls the phase of the
synchronized Modulator (see "Figure 3: Phase Shift" on page 8).
H
It is possible, to synchronize two or even three Modulators with Modulator
q
by setting the
adjacent sections to sync (left position). Also, Modulators
q
and
w
as well as Modulators
e
and
r
can be used as independent synced pairs.
CLK: The Modulator is either synchronized to an internal or external clock signal (see "Clock input (CLK IN)"
on page 12). Use
SPEED
- or
SPEED/PHASE
w
to select one of eight available clock division settings - the
Modulators’ speed will only move within a clock related grid.
Neither the internal clock nor an external signal is predefined. A clock can work with any resolution, e.g. with 4,
16 or 96 impulses per bar. Therefore, the clock division needs to be regarded relatively to this base.
Summary of Contents for fourMulator
Page 1: ...User Guide fourMulator...
