18
20306755
30ILDV Series Gas Fireplace Insert
INSERT INSTALLATION
GLASS FRAME REMOVAL
NOTE:
If the safety barrier is in place, you must first remove
it before you remove the glass frame. To remove the
barrier, simply lift up and pull out until the tabs are clear
of their corresponding slots on the firebox. Then proceed
to remove the glass frame by following the steps below.
1. Carefully remove upper filigree by pulling straight out.
2. Remove glass frame from insert by releasing two latches
on top of insert and lifting the door up and off the unit.
Figure 16
3. Set glass frame aside.
4. Re-install in reverse order.
Always use gloves when handling broken glass.
CAUTION
WARNING
Make sure the glass panel edges do not touch any metal
parts during thermal expansion.
DANGER
HOT GLASS
WILL
CAUSE BURNS
.
DO NOT TOUCH GLASS
UNTIL COOLED.
NEVER ALLOW CHILDREN
TO TOUCH GLASS.
Un panneau vitré chaud
peut
causer des brûlures.
Laissez refroidir le panneau
vitr
é
avant d’y toucher.
Ne laisser jamais
les enfants
toucher le panneau vitr
é
.
A barrier designed to reduce the risk of burns from
the hot viewing glass is provided with this
appliance and shall be installed.
Une barrière visant à réduire le risque de brûlure
par le hublot chaude est fournie avec cet
appareil et doit être installé.
DANGER
install glass frame
12/14
Glass Frame
Latches
Figure 16 -
Glass Frame Removal
Safety Screen
Barrier