Control Board
Cold Climate Switch
Master Switch
LED indicator
CFDV Series Gas Fireplace
6
20306739
PRE-INSTALLATION INFORMATION
BEFORE YOU START
Read this homeowner manual thoroughly and follow all
instructions carefully. Inspect all contents for shipping
damage and immediately inform your dealer if any damage
is found. Do not install any unit with damaged, incomplete,
or substitute parts. Check your packing list to verify that
all listed parts have been received. You should have the
following:
• Fireplace (Firebox and Burner System)
• Log
Set
• Rock
Wool
• Volcanic
Rock
ITEMS REQUIRED FOR INSTALLATION
Tools and Building Supplies:
• Phillips
Screwdriver
• Hammer
• Pliers
• Square
• Level
• Tee
Joint
• Pipe
Wrench
• Saw and/or saber saw
• Measuring
Tape
• Electric Drill and Bits
• Framing
Materials
W
ARNING
Do not fill spaces around firebox with
insulation or other materials. This could
cause a fi re.
FIREPLACE FRAMING
Firebox framing can be built before or after the appliance
is set in place. Construct fi rebox framing following
Figure
3 (page 6)
for specifi c installation requirements and for
fi rebox dimensions. The framing headers may rest on the
top of the fi rebox standoffs. Do not bring headers below
top of standoffs.
The fi rebox may be installed directly on a combustible fl oor
or raised on a platform of an appropriate height. When
the fi rebox is installed directly on carpeting, tile, or other
combustible material, other than wood fl ooring, the fi rebox
shall be installed on a metal or wood panel extending the
full width and depth of the enclosure.
Figure 2 –
CFDV Fireplace Controls–IPI (featuring Cold Climate option)
faster and more effi cient. Operating your appliance in cold
climate (aka standing) pilot mode will prohibit the need for
multiple ignition attempts and will prevent the system from
delaying start up or locking out.
To activate the cold climate option, simply move the cold
climate toggle switch located on the right side of the black
control center to the “On” (left) position. (
Figure 2)
You can
operate your appliance in this mode regardless of whether
you are using a remote control, wall switch or thermostat.
• Wall Finishing Materials
• Caulking Material (Noncombustible)
• Fireplace Surround Material (Noncombustible)
• Piping Complying with Local Codes
• Pipe Sealant Approved for use with Propane/LPG
(Resistant to Sulfur Compounds)