4
20004180
Connection to Gas Supply
NOTE: For Natural and Propane gas, you must have a manual
shutoff at the fireplace.
1. Place the burner pan in the fireplace. Two options are given to
place the burner under the grate in the fireplace; Option 1: Pull the
grate so that the back side of the hearth brick pulls up (1, Fig. 1)
enough for you to tilt the grate up (2, Fig. 1) to slide the pan under-
neath (3, Fig. 1). Option 2: Remove the two sheet metal screws
from the retaining brackets on the bottom feet of the rear grate legs,
then remove the grate. The burner should be located several inches
from the back wall, centered left to right.
NOTE:
If logset is installed in a fireplace other than the ODSHR42
fireplace, remove the grate that is in the fireplace and install the
grate listed on Page 12 of Optional Accessories.
CAUTION: If you answered “NO” to any item, or have any questions regarding your installation, please con-
tact your dealer/distributor for assistance.
8” adjustable crescent wrench; Pipe thread sealant compound or teflon tape; 12” pipe wrench or channel lock pliers.
Tools Required
Gas Log
Minimum Firebox Dimensions
Minimum
Gas Supply
Set
Input
Width
Flue
Pressure
Size
Btu/hr
Back
Front
Depth Height
Size
Minimum
Maximum
30”
90,000
27”
36”
18”
18”
79 sq.in.
3.5” w.c.
7.0” w.c.
Minimum Clearances & Specifications
Natural Gas Units
Propane Gas Units
Gas Log
Minimum Firebox Dimensions
Minimum
Gas Supply
Set
Input
Width
Flue
Pressure
Size
Btu/hr
Back
Front
Depth Height
Size
Minimum
Maximum
30”
60,000
27”
36”
18”
18”
79 sq.in.
11.0” w.c.
14.0” w.c.
Pre-Installation Checklist
Yes
No
Is the gas type you are using the same as the gas type listed on the rating plate for this
appliance?
Does the firebox meet the minimum size dimensions below?
Is the gas supply inlet pressure correct? Refer to Table below.
Is your fireplace plumbed with gas on the right side (facing) of the fireplace? If not,
refer to page 5.
Is the gas supply line sized properly (Minimum 1/2” Iron pipe)?
Do you have a solid fuel (wood burning) fireplace with a vented flue?
Do you have a manual gas supply valve installed at your fireplace? If not, a licensed
plumber, gas company technician or other qualified installer must install one:
Have you checked local building codes? (Check with your local building department)
Does your fireplace have a wire mesh screen in place?
FP1150
OD30
lift grate
9/10/01 djt
1
2
3
Fig. 1
Pull back of grate and hearth brick up, tilt front
of grate up and slide burner pan under.
FP1150
Summary of Contents for OD30CFLN/P
Page 13: ...13 20004180 ...
Page 14: ...14 20004180 ...
