30
30
Radiance
®
Direct Vent Gas Heater
30004967
,'
ALLLOGS
Operation
7!2.).'
(/4',!33
7),,
#!53%"52.3
$/./44/5#(
',!33
5.4),#//,%$
.%6%2
!,,/7#(),$2%.
4/4/5#(',!33
The Radiance is operated with the front plate in place with
the doors open or closed. To open the front doors, pull
forward to separate the magnetic catch.
CAUTION: DO NOT TOUCH DOORS WHEN
HOT!
Your First Fire
Read these instructions carefully and familiarize yourself
with the burner controls shown on Page 31. Locate the
pilot assembly, Figure 53. Follow the lighting instructions
on Page 31 exactly.
During the first fire, it is not unusual to smell some odor
associated with new logs, paint and metal being heated.
Odors should dissipate within the first eight to ten hours,
however, you can open a window to provide fresh air to
alleviate the condition.
Pilot and Burner Inspection
Each time you light your heater check that the pilot flame
and burner flame patterns are as shown in Figure 56. If
flame patterns are incorrect, turn the heater off. Contact
your dealer or a qualified gas technician for assistance. Do
not operate the heater until the pilot flame is correct.
ST477a
Stardance
pilot location
10/4/00
Fig. 55
Pilot Assembly location.
ST476
Pilot As-
sembly
Flame & Temperature Adjustment
For stoves equipped with HI/LO valves, flame adjustment is
accomplished by rotating the HI/LO adjustment knob located
near the center of the gas control valve. (Fig. 54)
Fig. 56
Flame adjustment knob for SIT valve.
LO
HI
FP390
FLAME ADJUSTMENT KNOB
11/21/96
Turn
counterclockwise
to increase
flame height
Turn clockwise
to decrease
flame height
Follow regular maintenance procedures as described on
Page 41.
CO105d
Fig. 57
Correct pilot and burner flame appearance.
LG491
Flame Characteristics
It is important to periodically perform a visual check of the pilot
and the burner flames. Compare them to Figure 55. If any
of the flames appear abnormal, call a service person.
CO105d
Pilot flame
6/07 djt
