– 1 –
FCC Class A
This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is
likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
FCC Caution
Any changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate this
equipment.
This transmitter must not be co-located or operating in conjunction with
any other antenna or transmitter. This device complies with Part 15 of the
FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including
interference that may cause undesired operation.
For products available in the USA/Canada markets, only channels
1–11 can be operated. Selection of other channels is not possible.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for
an uncontrolled environment. This equipment should be installed and
operated with minimum distance 20 cm between the radiator and your
body.
You are cautioned that changes or modifications not expressly approved
by the party responsible for compliance could void your authority to
operate the equipment.
You may use unshielded twisted-pair (UTP) for RJ-45 connections -
Category 3 or better for 10 Mbps connections, Category 5 or better for
100 Mbps connections, Category 5, 5e, or 6 for 1000 Mbps
connections. For fiber optic connections, you may use 50/125 or 62.5/
125 micron multimode fiber or 9/125 micron single-mode fiber.
Professional installation is required.
Industry Canada Statement
This Class A digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe A est conforme à la norme NMB-
003 du Canada.
This device complies with ‘Innovation, Science and Economic
Development (ISED) Canada’ license-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may
not cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada
applicables aux appareils radio exempts de licence. L’exploitation est
autorisée aux deux conditions suivantes:
(1) l’appareil ne doit pas produire de brouillage, et (2) l’utilisateur de
l’appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d’en compromettre le fonctionnement.
For product available in the Canada market, only channels 1 to 11 can
be operated. Selection of other channels is not possible.
Pour les produits disponibles aux Canada du marché, seul le canal 1 à
11 peuvent être exploités. Sélection d’autres canaux n’est pas possible.
Operation in the band 5150–5250 MHz is only permitted for indoor use,
to reduce the potential for harmful interference to co-channel mobile
satellite systems.
les dispositifs fonctionnant dans la bande 5150-5250 MHz sont réservés
uniquement pour une utilisation à l’intérieur afin de réduire les risques de
brouillage préjudiciable aux systèmes de satellites mobiles utilisant les
mêmes canaux.
For indoor use only. Pour une utilisation en intérieur uniquement.
Important note
For indoor use only.
Pour une utilisation en intérieur uniquement
This radio transmitter [26338-CSG1K3K] has been approved by
Innovation, Science and Economic Development Canada to operate with
the antenna types listed below, with the maximum permissible gain
indicated. Antenna types not included in this list that have a gain greater
than the maximum gain indicated for any type listed are strictly prohibited
for use with this device.
Le présent émetteur radio (26338-CSG1K3K) a été approuvé par
Innovation, Sciences et Développement économique Canada pour
fonctionner avec les types d'antenne énumérés ci-dessous et ayant un
gain admissible maximal d'antenne. Les types d'antennes non inclus dans
cette liste qui ont un gain supérieur au gain maximal indiqué pour tout
type listé sont strictement interdits pour une utilisation avec cet appareil.
The maximum antenna gain permitted for devices in the bands 5250-
5350 MHz and 5470-5725 MHz shall be such that the equipment still
complies with the e.i.r.p. limit.
le gain maximal d’antenne permis pour les dispositifs utilisant les bandes
5250-5350 MHz et 5470-5725 MHz doit se conformer à la limite de
p.i.r.e.
The maximum antenna gain permitted for devices in the band 5725-
5850 MHz shall be such that the equipment still complies with the e.i.r.p.
limits specified for point-to-point and non-point-to-point operation as
appropriate.
le gain maximal d’antenne permis (pour les dispositifs utilisant la bande
5725-5850 MHz) doit se conformer à la limite de p.i.r.e. spécifiée pour
l’exploitation point à point et non point à point, selon le cas.
Antenna List
1.
LTE: Wieson, P/N GY115HT0330-038
2.
WLAN: Wieson, P/N GY121HT0330-016
3.
Bluetooth: Maglayers, P/N PCA-3210-2G4C6-A1-TN
Type
Connector
Antenna Gain (LTE)
698-960
MHz
1710-2170
MHz
2300-2690
MHz
2.2
3.02
3.2
SMA-Male
Dipole
Type
Connector
Antenna Gain (WLAN)
2.4 GHz
5 GHz
4.55
3.1
RP SMA-Male
Dipole
Type
Connector
Antenna Gain (Bluetooth)
2.4 GHz
2.45 GHz
2.49 GHz
-7.08
-6.9
-5.59
MHF
PIFA
E092020-CS-R01
15020000xxxxA
S
a
f
e
t
y
&
R
e
g
u
l
a
t
o
r
y
I
n
f
o
r
m
a
t
i
o
n
Cloud Services Gateway
CSG1300 | CSG1500| CSG3300|CSG3500
