14105
Avalon
Boulevard,
Los
Angeles,
CA
90061
|
Tel
310-353-7100
|
Fax
310-353-7109
www.VersaTables.com
Add-on: Power Bar
Now tighten the 3 previously installed bolts with the provided
Phillips screw-driver
through holes on the cable management tray.
Pass the bolts through the widest portion of
the 3 middle keyholes on the
cable
management tray
by raising the tray onto
the underside of the desktop.
Then immediately slide the tray to either
side so that the bolts are over narrower
part of keyhole, making sure the back face
is flush with the back of the power bar.
Let go slowly yo ensure the bolts are
holding the tray up.
Pass the cable exiting the power supply
through the suqare hole on the cable
management tray.
Step 4
Step 3
Assembly
Step 5