14105
Avalon
Boulevard,
Los
Angeles,
CA
90061
|
Tel
310-353-7100
|
Fax
310-353-7109
www.VersaTables.com
M6x14 Machine screw
M6x10 Machine screw
Slide
control box (D)
off the frame. Fully separate
end frames
(A+C)
, you will find the
center rails (B)
inside.
NOTE:
End frame C is placed on the side of the desk you plan to mount the control box and controller.
We recommend using the right side.
Place
leg
into one of the
end frames
ensuring brackets
are towards the top.
Align holes on
leg
with holes on
end frame
and insert
four (4)
M6x10 machine screws
through the holes in
the
end frame
and into the
leg
. Using the supplied
Allen wrench
, rotate each screw just a few times.
After all four screws are inserted, tighten all.
Repeat this step for the other two pairs of leg and frame.
Slide the
side bracket
into the
end frame
.
Insert two (2)
M6x14 Machine screws
through the
hole on the bottom of the
end frame
and into the
side
bracket
. Using the supplied
Allen wrench
, rotate
each screw just a few times.
After both screws are inserted, tighten both.
Repeat this step for the other two leg/frame assembly.
Assembly
Step 1
Step 2
Step 3
x2
x4
B
A
C
D
