EVX-5400 O
pErating
M
anual
19
cated on the display.
r
The scanner will search the two channels and pause each time it finds a chan-
nel on which someone is speaking.
To stop Dual Watch
:
r
Press, (or press and hold), the assigned
PF
key. the “
DW
” icon disappear from
the display.
r
The radio receives the channel which was chosen when pressed the
PF
key.
Fm-s
can
(
F
olloW
-m
E
s
can
)
The FM-Scan feature checks a user-assigned priority channel regularly as you scan
the other channels. Thus, if only Channels 1, 3, and 5 (of the 8 available channels)
are designated for “scanning”, the user may assign Channel 2 as the “user-assigned”
priority channel via FM-Scan.
To activate FM-Scan, first select the channel you want to designate as the “user-
assigned priority channel” and press, (or press and hold), the assigned
PF
key.
The display indicates “
FM SCAN
” briefly. Then press, (or press and hold), the
Channel Up/Down key (generally the [
]/[
] key) to recall to the “Scanning
Start” channel which has been programmed by your dealer to activate the scanner.
When the scanner stops on an “Active” channel, the user-assigned priority channel
will automatically be checked every few seconds. If activity is found on the user-
assigned priority channel, the radio will switch between it and the dealer-assigned
priority channel, if any.
s
can
s
Et
Press, (or press and hold), the assigned
PF
key to add/delete the current channel
to/from your scanning list.
To store a particular channel to your scanning list, press, (or press and hold), the
assigned
PF
key; the display indicates “
SCN SET
” briefly and “ ” icon will ap-
pear on the display. If you delete a channel from your scanning list, press, (or press
and hold), the assigned
PF
key again; the display indicates “
SCN SKIP
” briefly
and the “ ” icon will disappear from the display.
When the scanner is paused, you may remove the channel from the scan list tem-
porarily by pressing, (or press and holding), the same key.
g
roup
s
can
s
Et
You may wish to have the Scanner pass through more than one Group during the
scanning process (normally, scanning is performed within the current group only).
To include the current Group in the scanning loop
, press, (or press and hold), the
a
dvancEd
o
pEratIon
