using this function. For different people tones are
different.
If the microphone is much too sensitive, noise from
surrounding areas may enable the TX, please
adjust sensitivity to a lower level.
If VOX gain is set to a high/sensitive level,
connecting the speaker/microphone to the radio
can amplify the RX signals and may cause TX.
OFFSET – VFO frequency offset
When offset frequency equals VFO TX frequency
minus RX frequency. The offset can be 00.000 to
69.995 MHz which is directly input by digit keys, and
the offset direction is selected by “
▲/▼
” keys for 3
options: none, “-“, and “+”. The positive (“+”) direction
means TX frequency will plus the offset on the current
displayed RX frequency, so as to the negative (“-“)
direction.
If the offset is set, the unit’s TX frequency display will
change when press “PTT” to transmit at repeater
mode.
STEP – VFO frequency step
Frequency step has 5 selections: 5.00KHz, 6.25KHz,
10.00KHz, 12.50KHz, and 25.00KHz. In VFO mode,
user can press “
▲/▼
” keys to increase / decrease RX
frequency with selected step.
CPS
It’s quite convenience to program following parameters
or functions by connecting the radio to a PC with a
compatible programming cable and run the VZ-88 CPS
program.
Channel Information setting
VZ-88 Radio has 128 channels, these channels can be
programmed by CPS, below parameters of each
channel can be set as well:
●
RX Frequency
●
TX Frequency
●
RX PL/ DPL
●
TX PL/DPL
●
Busy Lock
●
TX Stop
●
Roger Beep
●
Band Width
●
TX Power
●
Talk-Around / Repeater
●
PTT ID
●
Alias
VFO Information setting:
Enable/Disable VFO feature via CPS. The default
setting is Enable and support FPP function.
Following VFO parameters are set by CPS:
●
VFO Function Enable
●
RX Freq.
●
RX PL/ DPL
●
TX PL/DPL
●
Busy Lock
●
TX Stop
●
Roger B eep
●
Band Width
●
TX Power
●
Talk-Around / Repeater
●
PTT ID
●
Freq. Step
●
Offset Freq.
●
Offset Mode
29
CPS
Summary of Contents for VZ-88
Page 1: ...Operating Manual ...
