Jaws, magazine and pusher assembly
To Disassemble
1. Remove nylock nuts
VH0488
, washers
VH0221
, and latch spring
VC8102
from
the jaw screws
VH0489
.
2. Remove screws
VH0491
from rear of feeder guide rail.
3. Remove jaw screws from tool this will allow magazine and pusher assembly,
latch
VC8128
and jaws
VC8129
and
VC8130
with jaw bushings
VC8107
to be
removed from tool.
4. Remove button head screw
VH0033
from rail and magazine.
To Reassemble
1. Mount latch
VC8128
onto side plate opposite magazine.
2. Install jaw bushings
VC8107
into jaws
VC8129
and
VC8130
. Lubricate bushings
with lithium grease
VH0214
before installing.
3. Place jaws with bushings between side plates
VC8123
.
4. Slide magazine into position between spring spool bracket
VC8127
and side
plate. Attach magazine assembly to rear of feeder guide rail using screw
VH0033
and blue
Loctite (243)
. But do
not
tighten completely.
5. Insert jaw screws
VH0489
through spring spool bracket, magazine, side plate,
jaw bushing, side plate, latch spring and washers. Secure with nylock nuts.
Do
not over tighten
, jaws must pivot freely.
6. Reattach feeder guide rail to rear of tool using screws
VH0491
.
7. Tighten button head screw
VH0033
.
Rev H 4-30-2010
