2015/5/6V1.2+V1.1
13
is not pressed and fix the truss hex screw of stuff holder set(B
）
into gourd hole of upright
tube as figure 2-1, push it forward.After finished, tighten stuff holder(B) with screw(b) and
tighten the screw(a) that fixing the upright tube L,R. At last,cover the upper motor cover
back to frame(C) and tighten with cross screw.
STEP 3
Put computer console(A) on stuff holder(B) as figure 3-2, connect the control wire & other
wires of stuff holder(B) with wires of computer as figure 3-1. The put the connected wires
down to the place under flask holder set, that assembled before and fix with screw(f) &
spring washer(g), cover the computer decorative cover(L) and tighten with screw(d), when
cover it, please be sure to not press the wires.At last, tighten TPR handrail upper cover set
L,R(J,K) on stuff holder with screw(c).
Attention:
(1) When connect the wires,if the connecting is successful, it will have a voice.
(2)
TV cable
（
lower) is reardy for TV sysytems using
(3) To avoid danger, always assemble the treadmill with more than two workers, do
Hub plate connecting wire upper
Control wire upper
Control wire lower
TV cable lower
Power wire lower
TV cable upper
Power wire upper
Internet cable upper
Internet cable lower
Hub plate connecting wire lower
Summary of Contents for T22.1
Page 1: ...TREADMILL T22 1 OWNER S MANUAL...
Page 3: ...2015 5 6V1 2 V1 1 2 1 Overview Drawing...
Page 35: ...2015 5 6V1 2 V1 1 34...
