2015/5/6V1.2+V1.1
6
2.2. Add Lubricant
Use the Hex Wrench to unscrew the hex screws inside the Rear End Cap. Then pull the
belt up and daub some SILICON to the center of the board. After that, adjust the belt to the
center of the deck, followed by tightening the screw to the original set. Adjust the running
belt according to the above steps. Half a month should be checked once
Function of LUBRICATION REQUIRED
It will remind you to add lubricant when total distance added up to 2000Km(the
distance is difference with the levels of running belt). When restarting the treadmill next
time, the character string o
f “ LUBRICATION REQUIRED” will show on the screen and
then into start/ready status after continuously displaying for 1 minute.
Ps: When adding lubricant, check whether the lubricant in the running belt is dried up. If it
is, then add lubricant into it.
Cancel the character string of
“LUBRICATION REQUIRED” displayed on the screen
every time you restart the treadmill. After adding lubricant, restart the power and then it will
display the character string of
“LUBRICATION REQUIRED” for 1 minute on the screen.
During the one minute, press speed up key and speed down key at the same time. The
number will turn to 0 after 5 seconds and cancel the character string of
“LUBRICATION
REQUIRED” which will display until the next 2000km reach.
Summary of Contents for T22.1
Page 1: ...TREADMILL T22 1 OWNER S MANUAL...
Page 3: ...2015 5 6V1 2 V1 1 2 1 Overview Drawing...
Page 35: ...2015 5 6V1 2 V1 1 34...
