19
2015/3/9V1.0+V1.0
engineering mode.
※
Resident area only display at the standby page under the non-exercise status.
5.4. Standby page
Choose Quick start or other program control in this page. Go back to this page whenever
the exercise is over.
5.4.1. Date, time and address of the system will be shown in the page center.
5.4.2. Bottom of the page is menu area of program control, total 2 pages. Change to
the next page in the method of left or right sliding. Some program control has
sub-stage. Pop-up sub-menu after pressing program control title
5.4.3. Safety switch removal status
Whenever the safety key from the treadmill is removed, all the action will be
stopped immediately, and the picture will turn to this page, and the words
showed on the page is
”Safety Key removed”, at that time, any key and action
cannot be operated until the safety key is plugged into again.
5.5. Program control set page
5.5.1. Choose any program control in standby page, apart from Quick start, and then
enter into the set page of the program control.
5.5.2.
Input the age, weight, gender…of the user in specific program control, to be
substituted into the computational formula of the SPC.
5.5.3. After the set is finished, press start key, then enter into storage device ahead
the exercise, choose the page.