The pusher propeller should be mounted so that the propeller produces thrust towards the rear, this means
that the top of the propeller (the side that has the text engraved) should face the motor as shown in the
diagram below.
Note: When replacing propellers for the VTOL modules no lock bond is required as these are self-
tightening. When replacing the pusher motor propeller lock bond is required on the propeller adapter
nut as this motor can spin in both directions.
Note: All propellers are balanced in our factory by hand. This can leave scratch marks on the
propeller blades. This does not indicate damage or that the propellers are used. A sign of damage
can be structural weakness such as a bent propeller blade. If you find gouges or missing parts
anywhere at the tip, the outboard region, or the trailing edge of the blade you need to replace the
propeller.
Disassembly and storage
To disassemble the DeltaQuad open the lock pins for the wings and remove the wings.
Note: Never remove the carbon spars while the VTOL modules are attached. This could damage the wing-
joiners.
Note: Never store or put the vehicle with the LiPo battery inside the vehicle.
