9
Deleting a motor from all channels
Disconnect all motors from the power supply except the one you want to delete and follow this
procedure.
STOP
BUTTON
PROGRAMMING
BUTTON
1.
Press and hold the
stop button
for about
5 s
until the the
LED
indicator on the motor starts
flashing
RED
.
2.
Press and hold the
programming button
for
about
7 s
until the
LED
indicator on the motor
flashes
RED
7 times and then
BLUE
one time.
This motor has been deleted from all channels.
This is convenient when there has been a programming mistake and the motor needs to be reset
to its factory default settings. It is not necessary to turn off all motors previously programmed in
the remote control.
Resetting the motor to factory default
1.
Press and hold the
programming button
located on the head of the motor for about
3 s
until the
LED
indicator starts flashing
RED
quickly.
2.
Press and release
the
programming button
again until the
LED
indicator flashes
BLUE
one
time. All previous programming on the motor has
been deleted.
PROGRAMMING
BUTTON
PROGRAMMING
BUTTON
IMPORTANT:
The values, recommendations and instructions in this manual may vary at any time without previous notice.
They are not contractual and can not be used as claim for defective merchandise, order cancellations or returns.
For additional information contact your Vertilux representative or Vertilux Authorized Dealer.
Summary of Contents for 1-700-DM-00064
Page 20: ......