8
vertilux.com
© 2019. Vertilux, Ltd. All Rights Reserved. Last revised: February 2019.
A previously programmed remote control can be used in order to add a new remote control or
operating channel. Also, you can copy one channel to another in the same remote control using
this procedure.
1.
Using the previously programmed
Vertilux
remote, select the desired channel using the
channel selector button
, press and hold the
stop
button
for about
5 s
until the
LED
indicator on the
motor starts flashing
RED
.
2.
Using the new remote, select the desired
channel using the
channel selector button
, and
then press the
up button
. The led indicator will
flash
BLUE
3 times. The motor is now set on the
new remote control or channel.
STOP
BUTTON
PREVIOUSLY
PROGRAMMED
REMOTE CONTROL
NEW REMOTE
CONTROL
OR CHANNEL
UP
BUTTON
This is convenient when there has been a programming mistake and it is required to delete the
programming from a single channel. Also if you want to delete a programmed motor in a single
channel, turn off the power supply of all motors previously programmed in this channel except the
one you want to delete and follow this procedure.
Deleting a single motor or channel
1.
Select the desired channel using the
channel
selector button
, and press and hold the
stop
button
for approximately
5 s
until the
LED
indicator on the motor starts flashing
RED
.
2.
Press the
down button
for about
2 s
until the
LED
indicator flashes
BLUE
3 times. The selected
channel has been deleted. Drapery motors
previously linked to this channel are not linked
anymore.
STOP
BUTTON
DOWN
BUTTON
Adding an additional remote control or
“cloning” a channel
Summary of Contents for 1-700-DM-00064
Page 20: ......