Vertilux VTi, Programming Instructions Manual

5

vertilux.com

© 2018. Vertilux, Ltd. All Rights Reserved. Last revised: October 2018.

UNLOCKED

BUTTON

OPPOSITE DIRECTION 

BUTTON

RED AND BLUE

BUTTONS ARE

UNLOCKED

RELEASE

RED OR BLUE

BUTTON

5. 

On the wall control, press the 

stop button

 and 

then release the button that was pressed on the 

motor. 

6. 

Test the 

red

 and 

blue buttons

 again. At this 

time, both buttons should be able to emit a 

"click" sound when pressed. Both buttons are 

now unlocked, allowing for new limits to be set.

4.

 Press and hold the button that is unlocked on 

the motor until you complete step 5. On the wall 

control, press the 

button 

in

the 

opposite direction

to that selected in step 1 and allow the motor to 

operate until it stops on its own. 

STOP

BUTTON

RED OR BLUE

BUTTON IS

UNLOCKED

STOP

BUTTON

DIRECTION

BUTTON

Follow the procedure described in either 

Case #1

 or 

Case #2

 depending on your situation:

Case #1:

 Both motor buttons, the red and the blue ones, do not “click” when pressed.

Make sure you release the mechanism. To do this, remove the track

 COVER

 located on the side of 

the motor and remove the 

GEAR

 to release the mechanism 

(p. 2, fig. 2)

.

Resetting the motor to factory default

1.

 On the 

wall control

, press either 

direction 

button 

until the motor stops on its own. If the 

button you pressed does not start the motor, try 

the opposite 

direction button

. Remember which

direction button

 you selected in this step.

2. 

Press the 

stop button

 on the 

wall control

.

3.

 Test the 

red

 and

 blue buttons

 again. At this 

point one of them should be able to make a 

"click" sound. That button is now unlocked. 

The motor is now set to its factory default settings. Place the 

GEAR 

back. You can now follow the 

procedure to adjust the limits 

(p. 3)

.