Mechanical Installation
Vertiv
| Liebert
®
EXM
™
Parallel Cabinet User Manual |
6
Handling the unit with straps is not authorized.
1.4.2 Clearances
Liebert EXM Parallel Cabinet’s have no ventilation grilles at either side or at the rear. Clearance
around the front of the equipment should be sufficient to enable free passage of personnel with
the doors fully opened. It is important to leave a distance of 24" (610mm) between the top of the
cabinet and any overhead obstacles to permit adequate circulation of air coming out of the unit.
1.4.3 Floor Installation/Anchoring
The installation diagrams in
of this manual identify the location of the
holes in the base plate through which the equipment can be bolted to the floor. If the equipment
is to be located on a raised floor it should be mounted on a pedestal suitably designed to accept
the equipment point loading.
1.5
C
ABLE
E
NTRY
Cables can enter the Liebert EXM Parallel Cabinet from the bottom or top.
!
WARNING
Risk of moving heavy units and tipping hazard. Can cause equipment damage, injury and
death.
Exercise extreme care when handling cabinets to avoid equipment damage or injury to
personnel. The Liebert EXM Parallel Cabinet’s weight ranges from 263 to 714 lb. (119.3 to
323.8kg)
Locate center of gravity symbols
and determine unit weight before handling each
cabinet. Test lift and balance the cabinets before transporting. Maintain minimum tilt from
vertical at all times.
!
AVERTISSEMENT
Le centre de gravité élevé des appareils présente un risque de renversement lors des
déplacements pouvant entraîner des dommages matériels, des blessures et même la mort.
Faites preuve d’une extrême prudence lors de la manutention des armoires afin d’éviter de
les endommager ou de blesser le personnel. Les armoires de dérivation d’entretien EXM de
Liebert pèsent de 263 à 714 lb (de 119,3 à 323,8 kg)
Identifiez les symboles de centre de gravité
et déterminez le poids de l’appareil avant
de manipuler chaque armoire. Testez le levage et l’équilibre des armoires avant de
transporter l’appareil. Maintenez en tout temps l’inclinaison verticale minimale.