Vertiv™ XTE 802G Generator Room Walk-In-Cabinet Description and Installation Manual
12
Access Door and Hardware
•
Type: 16 gauge galvanized steel commercial grade insulated door.
•
Size: 48" x 84" outward opening.
•
Frame: 16 gauge galvanized steel frame.
•
Door Lock: KABA Simplex L1000 Series, Model 1021B, Mechanical w/Best core.
•
Hinges: (3) stainless steel with non-removable pin (per door).
•
Door Holder: positive engagement latch with bumper stop.
•
Closer: adjustable-hydraulic.
•
Drip Cap: 12" drip cap above doorway.
Master Ground Bar (MGB)
The XTE 802G contains one (1) 24-position galvanized steel Master Ground Gar (MGB) mounted to the outside of the right side of the
base assembly. The all-metal structure of the XTE 802G is bonded together using the PANI method for grounding.
Ground Bar (Interior)
A ten (10) position ground bar is located at the inside rear of the XTE 802G. This ground bar is mounted on isolators. The default
ground lug geometry is two hole with 1/4” post and 5/8” spacing.
NOTE!
Two (2) hole lugs are required on all ground bar terminations.
Lifting
The XTE 802G Generator Room is equipped with one lifting lug at the top of each corner that allow it to be lifted and lowered into
position. The base is also equipped with fork lift pockets that allow the use of a forklift to offload and lower to the mounting base at
the site.
Door Intrusion Alarm Switch
A door intrusion alarm switch is provided. See
for location and “Door Intrusion Alarm Switch Operation” on page 21 for
operation.
Alarms
The XTE 802G Generator Room is equipped with a door intrusion alarm switch. This switch can be wired to the alarm block located
on the XTE 802 Walk-In-Cabinet (WIC). The intrusion alarm triggers whenever the door is opened. It can be disabled by pulling the
alarm plunger completely forward.
Light Switch
A light switch is provided for the three (3) interior ceiling mounted LED lights. The light switch is located to the right of the door as
you enter.
Cable Entry Ports
•
The XTE 802G has one (1) cutout in the floor which is equipped with Roxtec 4/4 EzEntry ports (see
for location).
•
The XTE 802G also contains a floor access plate which contains four (4) 1.37 inch conduit knockout holes (see
for location).
•
The XTE 802G base pan also includes conduit knockouts (see
