Vertiv™ XTE 802G Generator Room Walk-In-Cabinet Description and Installation Manual
35
6.5
Transportation and Storage
Safety Precautions
WARNING!
PREVENT INJURIES, FROM LIFTING THE XTE 802G
Follow all local safety practices while lifting the XTE 802G. Safety equipment, signage, traffic control and all required Personal
Protective Equipment (PPE) shall be used.
Keep unnecessary personnel and bystanders clear of work areas at all times.
Do not lift the XTE 802G over people. Do not let anyone work, stand, or pass under a lifted XTE 802G.
Do not move or lift the XTE 802G with a door open.
Only properly trained and certified operators shall operate any crane or lifting equipment.
Do not allow the lifting equipment or XTE 802G to touch any electrical wiring or equipment.
Operate all lifting equipment within safety constraints, as defined by the manufacturer and local practices; for example, do not
exceed the capacity of reach.
Crane Operation:
Only properly trained operators shall operate the crane.
Do not operate the crane until all stabilizers are extended. The stabilizers must be in firm contact with the ground or other
adequate support structure. Do not retract or extend the stabilizers when the XTE 802G is suspended from the crane.
Only the crane rigging crew should set up the crane and rigging.
Do not exceed the lifting capacity of the crane.
Use all four (4) provided lifting points (eyes) at the top corners of the XTE 802G to lift the XTE 802G.
Use crane spreader frames to prevent XTE 802G framework warping due to side loading.
Never route straps, cables or chains through the fork-lift channels in the base for a vertical crane lift.
Do not use slings, clevises or shackles of insufficient capacity.
Forklift Operation:
Only properly trained operators shall operate the forklift.
Do not exceed the lifting capacity of the forklift.
Forklifts shall have a minimum fork length of 72 inches (183 cm).
