Vertiv™ XTE 802G Generator Room Walk-In-Cabinet Description and Installation Manual
39
6.8
Lifting the XTE 802G
Safety Precautions
DANGER!
The maximum XTE 802G weight when lifted shall not exceed equipment ratings!
Procedure (When Using a Crane)
1.
Close and latch all doors before lifting and placing the XTE 802G.
2.
Inspect the lifting eyebolts and ensure eyebolts and roof are secure and free of damage.
3.
Install a clevis and shackle or a threaded shackle in each eyebolt at the top of the XTE 802G as shown in
4.
Insert all four (4) 8 feet minimum lifting slings securely through all four clevises or shackles as shown in
. Never
route straps, cables or chains through the forklift channels in the base for a vertical crane lift.
NOTE!
If slings are not long enough (8-ft. [2.4 m] or longer), use a spreader bar to be sure the cables pull on the lifting
eyebolts in a vertical direction.
NOTE!
It is important that the length of each sling allow for an angle 45 degree or more.
NOTE!
Failure to maintain a 45 degree angle or greater and using all four eyebolts will void any warranty or service claim.
5.
Tie a 75-ft. rope to a lifting eyebolt so it can be used as a tag line.
6.
Never work under the XTE 802G while it is suspended above the ground.
7.
Lift the XTE 802G off the truck and place it into its mounted position using the tagline to guide it into position. Continue with
the “Placing the ” procedure on 41.
Procedure (When Using a Forklift)
1.
Close and latch all doors before lifting and placing the XTE 802G.
2.
Lift the XTE 802G using the forklift pockets located in the base of the XTE 802G.
3.
Never work under the XTE 802G while it is suspended above the ground.
4.
Lift the XTE 802G off the truck and place it into its mounted position. Continue with the “Placing the ” procedure on 41.
