Vertiv™ XTE 802G Generator Room Walk-In-Cabinet Description and Installation Manual
21
4
Front Door
4.1
Safety Precautions
DANGER!
RISK OF ELECTRICAL SHOCK, AC
Proper actions, include, but not limited to:
•
Verify before contacting the XTE 802G that no current leakage or ground fault condition is present.
•
Verify a proper ground is in place.
WARNING!
RISK OF EXPLOSION
For safety reasons, never restrict or block the airflow through the door or entry panel ventilation openings.
4.2
Locking Mechanism
The front door is equipped with a KABA Simplex L1000 Series, Model 1021B, Mechanical w/Best core door lock.
4.3
Securing Mechanism
The front door is equipped with a positive engagement latch with bumper stop to secure the door in an open position and an
adjustable-hydraulic closure.
4.4
Door Intrusion Alarm Switch Operation
The front door is equipped with a door intrusion alarm switch. The intrusion alarm switch can be connected to the alarm block
located on the XTE 802 Walk-In-Cabinet (WIC). If connected to an alarm sending device, an alarm can be sent whenever the front
door is opened. The intrusion alarm can be disabled while performing routine maintenance as described in the following procedure.
Refer to
on page 19 for location of the intrusion alarm switch. Refer to
for an illustration of the intrusion alarm
switch.
Procedure
1.
Open the front door. If connected properly, the intrusion alarm activates.
2.
Pull the plunger on the switch to silence the alarm.
3.
The intrusion alarm can be reset by pushing the plunger back in, or by closing the front door.
Figure 4-1:
Intrusion Alarm Switch
Front Door Intrusion Alarm Switch View
