•
Additional inspection of the unit is warranted to ensure no exterior or internal damage.
Report damage immediately to the carrier and file a damage claim with a copy sent to Vertiv™ or to your sales
representative.
3.5 Moving the Packaged Unit
Transport the unit with a forklift. When using the forklift:
•
Make sure the fork length is suitable for the width of the pallet.
•
Do not tilt the unit more than 20 degrees in any direction to prevent the unit from falling over.
•
When moving the packaged unit, do not lift it any higher than 102 mm (4 in.) off the ground. Exercise great care
if the unit must be lifted higher than 102 mm (4 in.).
•
Refer to the following figure for the location of the center of gravity.
Figure 3.4 Center of Gravity
Center of Gravity
Distances from Corner
X ± 50 mm (2 in.)
Y ± 50 mm (2 in.)
Z ± 100 mm (3.9 in.)
CRD25
148 mm (5.8 in.)
573 mm (22.6 in.)
927 mm (36.5 in.)
CRD35
272 mm (10.7 in.)
583 mm (23 in.)
923 mm (36.3 in.)
3.6 Unpacking the Unit
To unpack the unit:
1.
Pull straight the latches on the wooden box using a claw hammer.
3 Pre-installation Preparation
14
Vertiv™ Liebert® CRV CRD25 and CRD35 Row-Based Cooling System User Manual
