Vertiv
| Liebert
®
ITA2
™
User Manual |
12
2.0
SINGLE UPS INSTALLATION AND
COMMISSIONING
This chapter introduces the installation, cable connection and commissioning of the single UPS.
Because each site is different, this chapter provides general installation procedures and methods
for the installation engineer who should conduct the installation according to the site conditions
and requirements.
2.1
Unpacking and Inspection
The 8 and 10kVA models are shipped in a cardboard box. To unpack the UPS:
1.
Stand the box upright.
2.
Open the carton and remove the packing.
3.
Lift out the accessories and set them aside.
4.
Lift the UPS out of the box and stand it or lay it aside.
5.
Remove the UPS, as shown in
.
WARNING
Risk of improper installation. Can cause property damage, injury or death.
The UPS must be installed according to the information contained in this chapter by
properly trained and qualified personnel. If any problem is found, contact Vertiv Support
immediately at 800-543-2378.
The UPS must not be powered On without approval of the commissioning engineer.
NOTE
Three-phase, five-wire for power input—The UPS can be connected to three-phase, five-wire (A,
B, C, N, PE) TN, TT and IT AC power distribution system (IEC60364-3).
Summary of Contents for Liebert ITA2-08KRT208
