OPTION
70
User Manual 10H52246UM60 - Rev. 1 - 01/2017
8.1.2
Internal Battery Kit
Vertiv can supply two different types of internal battery kits for the users that require internal UPS battery solutions
or corresponding kits:
- A factory installed, 40-block internal battery kit
- A site installed kit including battery cables, battery trays, screws, cable ties, protective caps and battery fuses.
Note: In the case of the factory installed 40-block internal battery kit, Vertiv provides - GP 12340-12V-34.0Ah
valve-regulated lead acid batteries (see Table 8-2 for parameters) or equivalent model.
Table 8-2
GP 12340-12V-34.0Ahvalve-regulated lead acid battery parameters
Dimensions
Overall height (H)
Container height (h)
Length (L)
Width (W)
mm
(inch)
178.3±2 (7.02±0.08)
154.8±2 (6.09±0.08) 195.6±2
(7.7±0.08) 130±1.5
(5.12±0.06)
Note
1. The site installed, 40-block internal battery kit DOES NOT include batteries
2. The battery cables, battery trays and protective caps are designed according to the specifications of the GP
12340-12V-34.0Ah valve-regulated lead acid batteries or equivalent model. If you request the site installed, 40-block internal
battery kit, please purchase batteries of the same specification.
Preparation
1. Prepare the installation tools, including a cross head screwdriver, a pair of insulated gloves, a sleeve, an adjustable
spanner, and a multi-meter.
2. Check that all installation materials are present and complete, including internal battery, eight battery trays and
corresponding battery power cables.
Procedures
1. Shut down the UPS completely.
a) Shut down the load.
b) Refer to 5.6.1
Procedures for Shutting Down a UPS completely
when shutting down a single UPS module, and
7.3.5
Procedures For Shutting Down a UPS Completely in a Parallel System
when shutting down a parallel system.
c) All the LCDS switch off, wait five minutes for the internal UPS DC bus capacitors to discharge completely.
2. Install the internal battery fuse and the battery cables.
Open the cabinet front door, remove the switch cover, side panel and rear panel, and then install the cables (W19,
W20 and W21), as shown in Figure 8-6.