24 Chapter 3 Web Page Of RDU-A G2
RDU-A G2 Intelligent Monitoring Unit User Manual
1. If some signal is in alarm status, it will be displayed in red.
2. You can click the corresponding signal name for modifying or restoring, as shown in Figure 3-22.
Figure 3-22 Modifying signal name
Note
For ENV-TH and ENV-4DI devices, see the following descriptions:
1. After modifying the name of
Sampling
signals, the names of
Control
,
Setting
and
Alarm
will be modified at the same time;
2. On the
Control
,
Setting
and
Alarm
pages, it is prohibited from modifying the signal name.
Control
Clicking the
Control
tab can enter the control page, which displays control signals of selected device, as shown in
Figure 3-23.
Figure 3-23 Control signals
1. Clicking the
Set
button can control the device.
2. For the name of
Control
signals (except ENV-TH and ENV-4DI), you can click the corresponding signal name for
modifying or restoring, as shown in Figure 3-23.
Setting
Clicking the
Setting
tab can enter the setting page, which displays setting signals of selected device, as shown in
Figure 3-24.
Figure 3-24 Setting signals
1. You can set several signals at the same time, and at most 16 signals can be set at the same time for each time.
