background image

To contact Vertiv Technical Support: visit www.VertivCo.com

© 2017 Vertiv Co. All rights reserved. Vertiv and the Vertiv logo are trademarks or registered trademarks of Vertiv Co. All other names and logos referred to are trade names, 

trademarks or registered trademarks of their respective owners. While every precaution has been taken to ensure accuracy and completeness herein, Vertiv Co. assumes no 

responsibility, and disclaims all liability, for damages resulting from use of this information or for any errors or omissions. Specifications are subject to change without notice.

LIEBERT® OUTDOOR CONTROL ENCLOSURE™

Quick Installation Guide

  

1734-501A/SL-10060_REV5_9-17

  

TECHNICAL SUPPORT 

AND SERVICE
Vertiv Services, Inc.

24x7 dispatch of technicians for all 

products.

1-800-543-2378

Liebert Thermal 

Management Products

1-800-543-2778

Liebert Channel Products

1-800-222-5877

Liebert AC and DC 

Power Products

1-800-543-2378

LOCATIONS
United States

Vertiv Headquarters
1050 Dearborn Drive
Columbus, OH, 43085, USA

Europe

Via Leonardo Da Vinci 8 Zona 

Industriale Tognana
35028 Piove Di Sacco (PD) Italy
+39 049 9719 111
Fax: +39 049 5841 257

Asia

7/F, Dah Sing Financial Centre
3108 Gloucester Road, Wanchai
Hong Kong 852 2572220
Fax: 852 28029250

Summary of Contents for Liebert

Page 1: ...witch and earth ground to unit per NEC CEC and local codes as applicable Failure to comply can cause injury or death NOTICE Risk of water leaks Can cause equipment damage NOTE To flush mount the back of the enclosure the adjustable brackets can be inverted Refer to the Dimensions drawings on the following page NOTE Alternate mounting locations are on a secure wall or building surface Use the provi...

Page 2: ...t have to be the same voltage as the Liebert indoor unit This separate power source may be 110V 208V 230V 460V or 575V single phase or three phase 60Hz or it may be 200V 230V 380V or 415V single phase or three phase 50 Hz as appropriate Extra low voltage Control Wiring Control interlock between the control enclosure and the indoor unit s or other source s is required Multiple indoor units may be c...

Page 3: ...ll for cooling the compressor contactor and or the Econ O Coil relay in the Liebert unit is energized The relay and contactor are in the Liebert indoor evaporator section Each compressor contactor has a side switch wired in parallel with the Econ O Coil relay and is responsible for closure of the low voltage pump control circuit This low voltage circuit has a series of contactors relays selector s...

Page 4: ...missions Specifications are subject to change without notice LIEBERT OUTDOOR CONTROL ENCLOSURE Quick Installation Guide 4 1734 501A SL 10060_REV5_9 17 TECHNICAL SUPPORT AND SERVICE Vertiv Services Inc 24x7 dispatch of technicians for all products 1 800 543 2378 Liebert Thermal Management Products 1 800 543 2778 Liebert Channel Products 1 800 222 5877 Liebert AC and DC Power Products 1 800 543 2378...

Reviews: