Vertiv
|
NetSure™ 2100 Series -48 VDC Power System Installation Manual (IM582138000)
|
Rev. C
70
Connecting to an Optional Battery Cabinet
NetSure™ 211BC Battery Cabinet, P/N 541434
Refer to the battery cabinet instructions (Section 6023).
NetSure™ 211BC Battery Cabinet, P/N 545534
Refer to the battery cabinet instructions (Section 6033).
NetSure™ 211BC Battery Cabinet, P/N 545506
Refer to the battery cabinet instructions (Section 6036).
NetSure™ 211BC Battery Cabinet, P/N 554631
Refer to the battery cabinet instructions (UM554631).
Installing and Connecting Batteries in an Optional List 93 or 94 Battery Tray (if furnished)
Important Safety Instructions
DANGER!
Adhere to the “Important Safety Instructions” starting on page 7.
Installing and Connecting Batteries
Procedure
Tray P/N 559806 is used in the following procedure. The procedure for all other available trays is similar.
NOTE!
as this procedure is performed. See also
1.
If Battery Trays are Equipped with a Circuit Breaker:
Turn OFF the battery disconnect circuit
breaker located on all battery trays. Refer to
for locations. Follow local lockout/tagout
procedures to ensure circuit breakers remain in the off position during installation.
2.
Remove the battery retention bracket as shown in
. To do so, remove the four 1/4-20 x 5/8”
bolts and associated washers.
3.
Slide batteries into the tray, with the battery terminals toward the front as shown in
. Slide
batteries into the tray as far as they will go.
NOTE!
The battery retention bracket can be oriented two ways to accommodate batteries of different
lengths. A correctly oriented bracket will fit snuggly against the batteries. If your batteries require the
alternate bracket orientation shown in Detail A of
, remove and reinstall the bullet-shaped
spacers (if furnished) as shown in Detail A before performing the next step.
4.
Reinstall the battery retention bracket. The spacers on the bracket should separate the batteries from
each other. Secure with the hardware removed in a previous step. Refer to
location.
