VES, LLC
Elite-RS Panel Installation Manual
VF3529-00, Revision E01.03
H-Series
FCC
VES, LLC
This equipment complies with Part 68 of the FCC rule and the requirements adopted by the ACTA. On the Inside cover of this equipment is a label that
contains, among other information, a product identifier US:KNTAL00BASA-FACP. If requested, this number must be provided to the telephone company.
The Integrated Dialer is incorporated on the Main Board of the Elite-RS Panel to provide TELCO communication on certain models.
Connect permissive data equipment to TELCO line 1 and line 2 of the Elite-RS Panel using independent RJ31X jacks. Reference Section 3, Installation,
Connecting Communication, page 25 of this manual for details concerning these connections.
Reference the following:
- ATIS Technical Report No. 5 for connector details
- Facility Interface Code 02LS2
- Service Order Code 9.0Y
A plug and jack used to connect this equipment to the premises wiring and telephone network must comply with the applicable FCC Part 68 rules and
requirements adopted by the ACTA. A compliant telephone cord and modular plug must be used. It is designed to be connected to a compatible modular
jack that is also compliant. See installation instructions for details.
This product’s REN is 0,0. The REN is used to determine the number of devices that may be connected to a telephone line. Excessive RENs on a
telephone line may result in the devices not ringing in response to an incoming call. In most but not all areas, the sum of RENs should not exceed five
(5.0). To be certain of the number of devices that may be connected to a line, as determined by the total RENs, contact the local telephone company. The
REN for this product is part of the product identifier that has the format US:AAAEQ##TXXXX. The digits represented by ## are the REN without a
decimal point (e.g., 03 is a REN of 0.3). The REN is separately shown on the door label.
If the terminal equipment Fire Alarm Control Panel causes harm to the telephone network., the telephone company will notify you in advance that
temporary discontinuance of service may be required. But if advance notice is not practical. the telephone company will notify the customer as soon as
possible. Also, you will be advised of your right to file a complaint with the FCC if you believe it is necessary.
The telephone company may make changes in it's facilities. equipment, operations or procedures that could affect the operation of the equipment. If this
happens the telephone company will provide advance notice in order for you to make necessary modifications to maintain uninterrupted service.
If trouble is experienced with this equipment Fire Alarm Control Panel, for repairs or warranty information, please contact VES, LLC 620 Allendale Rd,
King of Prussia, PA. 19406 (800)274-9514. If the equipment is causing harm to the telephone network., the telephone company may request that you
disconnect the equipment until the problem is resolved.
Reference Section 5, Maintenance and Repair of this manual for details describing standby battery and fuse replacement. No other user serviceable
components are contained within this assembly. Contact VES, LLC technical support for diagnostic assistance when necessary. Reference Section 1,
Introduction of this manual for details describing technical support, Return Material Authorization (RMA), Warranty Returns, Advanced Replacements
and the Product Return Address.
Connection to party line service is subject to state tariffs. Contact the state public utility commission, public service commission or corporation
commission for information.
If your home has specially wired alarm equipment connected to the telephone line, ensure the installation of this Fire Alarm Control Panel does not
disable your alarm equipment. If you have questions about what will disable alarm equipment, consult your telephone company or a qualified installer.
Reference the Loop Explorer Configuration Manual, AW-000104, Section 4, Programming, page 10 for details describing the programming of this
assembly.
