121
10.7.8
Removing the Driving Pulley
-
With the pulley stop wrench correctly inserted
into the apposite slits, remove the lock nut.
Note:
The nut has an ‘in-built’ spring washer.
Specific equipment and tools:
Driving pulley stop wrench
020442Y
-
Remove the starting rim assembly.
-
Remove the driving fixed half-pulley, together
with the O-ring and the steel washer on the
bushing.
-
Remove the belt and extract the moving half-
pulley with the relevant bushing
Note:
The rollers are freely placed onto the slides
inside the pulley. Ensure that they don’t fall when
the pulley is being removed.
-
Remove the roller contrast plate with the
relevant guide sliding blocks
10.7.9
Removing the Driven Pulley
-
Remove the spacer, the clutch drum and the
entire driven pulley assembly.
Note:
This operation may be performed without
removing the driving pulley assembly.
Summary of Contents for GT 200
Page 1: ......
Page 90: ...90 9 1 2 Turn Signal Lights Horn Services and Accessory Pre Wiring ...
Page 151: ...151 10 10 Lubrication Circuit ...
