123
10.7.12
Removing the Clutch
-
Prepare the driven pulley spring compressor
(020444Y) with the medium length pins in
position «C» tightened on the inside of the tool.
-
Introduce the adapter ring no. 11 with the
chamfering facing the inside of the tool.
-
Install the driven pulley assembly onto the tool
inserting the three pins into the ventilation holes
on the mass holding support.
-
Make sure that the clutch is perfectly inserted
into the adapter ring before proceeding to
release and tighten the clutch nut.
-
Using the specific 46
×
55mm wrench remove the
clutch fixing nut.
-
Separate the components of the driven pulley
(clutch and spring with plastic rest).
Specific equipment and tools:
Driven pulley spring compressor
020444Y
Wrench (46
×
55mm)
020444Y009
Adapter ring
020444Y011
Caution
– The toll must be tightly fixed in the vice
and the central screw must be moved in abutment
with the tool. An excessive torque may deform the
specific tool.
10.7.13
Disassembling the Fixed Driven Half-Pulley Bearings
-
Check for any noise and/or signs of wear. If the
bearings are worn or noisy, replace them.
-
Remove the retaining ring using two flat
screwdrivers.
-
Use a suitable wooden surface to support the
bushing from the threaded side.
-
Using a pin and a mallet, remove the bearing, as
shown in the figure.
Summary of Contents for GT 200
Page 1: ......
Page 90: ...90 9 1 2 Turn Signal Lights Horn Services and Accessory Pre Wiring ...
Page 151: ...151 10 10 Lubrication Circuit ...
