125
10.7.15
Checking the Moving Driven Half-Pulley
-
Remove the two inner sealing rings and the two
O-rings.
-
Measure the internal diameter of the bushing, as
shown in the figure.
Standard dimension:
Bushing diameter
∅
1.599-1.600 in
(
41.000-41.035mm
)
Min. allowable dimension:
Bushing diameter
∅
1.602 in
(
41.080mm
)
-
Ensure that the working surface (in contact with
the belt) is free from abnormal wear.
-
Check the riveting.
-
Check the planarity of the working surface.
Wear limit:
Fixed Driven pulley planarity
0.0012 in
(
0.03mm
)
10.7.16
Fitting the Fixed Driven Half-Pulley Bearings
-
Ensure the pulley bushing is suitably supported
from the threaded side on a wooden surface.
-
Install the new roller casing as shown in the
figure, ensuring that the inscription is facing
outwards.
Specific equipment and tools:
Punch for roller casing
020424Y
Summary of Contents for GT 200
Page 1: ......
Page 90: ...90 9 1 2 Turn Signal Lights Horn Services and Accessory Pre Wiring ...
Page 151: ...151 10 10 Lubrication Circuit ...
